Aluminum is crucial in various industries such as aerospace, transportation, construction, medical devices, and general manufacturing. It possesses good electrical and thermal conductivity and can even act as a super conductor. Taksh Steel India provides a wide variety of aluminum forms including sheet, coil, pipe, tubing, plate, and bar, along with an extensive range of aluminum grades and sizes.
Aluminium Grades Available
- 1100 – Coil
- 1100 – Plate
- 1100 – Round Wire
- 1100 – Sheet
- 2014 – Hex Bar
- 2014 – Rectangular Bar
- 2014 – Round Rod
- 2014 – Square Bar
- 2024 – Hexagon Round
- 2024 – Plate
- 2024 – Rectangular Bar
- 2024 – Round Rod
- 2024 – Square Bar
- 2024 – Sheet
- 2219 – Bar
- 2219 – Extrusion
- 2219 – Plate
- 2219 – Sheet
- 7050 – Plate
- 7075 – Rectangular Bar
- 7075 – Sheet
- 7075 – Plate
- 7075 – Round Rod
- 7178 – Extrusion
- 7178 – Plate
- 7475 – Plate
- 7475 – Sheet
- 2011 – Round Rod
- 2011 – Hexagon Rod
- 2017 – Round Rod
- 3003 – Coil
- 3003 – Plate
- 3003 – Sheet
- 3003 – Tube
- 5005 – Coil
- 5005 – Sheet
- 5052 – Coil
- 5086 – Plate
- 5086 – Sheet
- 5086 – Coil
- 5657 – Coil
- 5657 – Sheet
- 6070 – Plate
- 6070 – Sheet
- 6070 – Round Rod
- 6060 – Angle
- 6060 – Channel
- 6060 – Coil
- 6060 – Hexagon/Round
- 6061 – I-Beam
- 6061 – Pipe
- 6061 – Plate
- 6061 – Round Bar
- 6061 – Sheet
- 6061 – Square Bar
- 6061 – Square Tube
- 6061 – Tee
- 6061 – Tread Plate
- 6061 – Tube
- 6063 – Angle
- 6063 – Channel
- 6063 – Pipe
- 6063 – Rectangular Bar
- 6063 – Rectangular Tube
- 6063 – Round Bar
- 6063 – Square Bar
- 6063 – Square Tube
- 6351 – Rectangular Bar/Bar
- 6262 – Round Rod
Aluminium Temper Designations
The temper designation follows the alloy code and is separated by a hyphen.
F
As Fabricated
This applies to products of rolling or forming where there is no special control over the thermal or work-hardening conditions. Since mechanical properties may vary widely, no limits have been assigned. This temper usually applies to sheet products, which are at intermediate stages of production.
H
Strain-Hardened
Applies to wrought products that are strengthened by cold-rolling or cold-working.
T
Heat Treated
Applies to wrought products that have been heated above the recrystallization temperature to produce the alloy's lowest tensile strength.
